6 Simple Home Repairs You Can Do Yourself


A home is one of the most expensive purchases you will ever make. That is why it should be properly maintained whether you are buying or renting.

In most cases, you will have to call professionals if a problem needs to be resolved. However, some of these issues can be easily fixed and you can save a lot of money.

Much of the home improvement and repair work can be done with little or no experience None at all. However, it is important to do some research with home repairs such as: B. Electricity, which is known to be a dangerous solution.

Simple home repairs that you can do yourself to save money

Here are some simple home repairs that you can do yourself:

Clog the toilet drain

A quick trip to the bathroom followed by a single flush and you’re faced with a clogged drain or, worse, an almost overcrowded toilet. To share a toilet drain, you need a toilet plunger.

Proceed like this:
  1. Pour enough water to submerge the piston head.
  2. Perform 8-10 vigorous downward strokes to clear minor blockages.
  3. Use a toilet snail if the blockage is still there.
  4. The end of the auger should go down the toilet to the point where it becomes clogged and the crank begins to turn.

Have a good grip and pull the blockage out.

Leaking bathroom / kitchen pipe

Bathroom remodel ideas

Find and repair smaller droplets before they cause major damage. These are common and usually involve a broken or loose compression nut or worn washer.

Follow these steps:
  1. Turn off the water to the sink.
  2. Put a bucket under the pipe.
  3. Unscrew the pressure nuts from the pipe.
  4. Flush the P-trap (bent tube).
  5. Replace the washer and screw it back.
  6. Turn on the water.

Replace light switch

Most of the wall switches in your home are single pole switches that control a light or socket outlet from a single wall location. Dealing with light switches is pretty easy.

Replace a defective light switch as follows:
  1. Turn off the circuit breaker before you begin.
  2. Remove the front panel using a flat-blade screwdriver.
  3. Use the screwdriver to carefully remove the light switch from the wall.
  4. Test the wires that connect to the screws on the light switch.
  5. Disconnect the cables before connecting them to a new switch.
  6. Screw everything back on.

Loosen stuck windows

To do this, you need high quality elbow grease.

Follow these steps:
  1. Use a pizza cutter to pry your sash out of the frame. Alternatively, use something that is less sharp to open up the edges so that you get the color in.
  2. When you finally get the window moving, clean the window thoroughly as the problem was caused by dirt.

Patch holes in dry walls

Getting a hole in dry walls is very inevitable, even for people who only rent. Attaching them is easy, especially in the case of nail holes or screw holes.

Carry out the repairs as follows:
  1. First, properly clean the damaged area from debris and wipe the wall.
  2. Using a good spatula, press a small amount of spatula into the wall and let it dry.
  3. Sand it down with fine grain sandpaper for a flat and beautiful finish.
  4. You can add a coat of paint if you want.
For large holes, do the following:
  1. Cut out a rectangular section of the wall that will surround the hole.
  2. Cut a fair bit of drywall from pieces of branch in the store or from scraps.
  3. Use small pieces of wood as stiffeners on the scrap drywall inside the hole. It should be inserted into the wall and drilled with screws on both the top and bottom. A third screw should be attached to the drywall.
  4. Add drywall tape around the seams.
  5. Finally, foam up a grout and scrape it off with a large spatula.
  6. When the joint dries, sand it down.
  7. Paint if you want.

Floor repair

Sometimes your hardwood floor can be damaged by termites and needs to be repaired.

Repair of parquet floors is carried out as follows:
  1. The area where the parquet will be installed must be cleaned.
  2. Buy a glue and parquet tiles.
  3. Glue the tiles each with the thick glue you bought.
  4. Get a soft parquet brush and paint to bring the wood to its original dark color that you desire.
  5. Sand the parquet tiles with sandpaper to a smooth finish.
  6. Use wood paint of the color you want to coat the parquet tiles.
  7. Paint the parquet floor with a varnish.

The list of simple home repairs that you can easily do yourself is not exhaustive as there are many more.

Home repairs don’t have to be expensive anymore as you can do them yourself as described above. However, make sure that you are using the correct tools to minimize injury and not further damage your home in the process.


The best apps to save real money

We talk a lot on the phone, don’t we? Wouldn’t it make sense to save money with the best money-saving apps?


Please enter your comment!
Please enter your name here